360 / 365 size brushed DC motor: Ø27.7 × 32.6 mm, 2 × M2.6 on 16 — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/dc-motor-365-size/ (CC BY 4.0) Basis: Mabuchi RS-360RH and RS-365SH dimension drawings. Envelope only: the outside of the motor at its published sizes. The windings, magnets, brushes and bearings inside are not drawn. Catalog version: 2026-10-20 Sizes: see table below - Envelope only: the outside of the motor at its published sizes. The windings, magnets, brushes and bearings inside are not drawn. - The can is Ø27.7 × 32.6 with a Ø10.0 × 2.6 boss on the front face and another on the end cap. - The Ø2.3 shaft runs 15.6 mm out from the front face on the 365 and 11.6 mm on the 360; the cans are the same. The drawings' overall lengths (51.0 and 47.0) are 0.2 longer than the drawn parts. - Two M2.6 × 0.45 tapped holes on 16.0 mm centres in the face, drawn at the thread's major diameter as deep as the usable screw length on the drawing (3.0 on the 365, 4.0 on the 360). - Vent holes, terminal tabs and the wire exit are not drawn. - In DIY Stirling builds, brushed DC motors of this kind are turned by the engine and used as a generator (an LED, a resistor or a meter across the leads) or as a load on the flywheel shaft. feature mm from can Ø27.7 × 32.6 Mabuchi RS-360RH / RS-365SH front and rear boss Ø10.0 × 2.6 Mabuchi drawings shaft Ø2.3 Mabuchi drawings shaft from the face 15.6 (365) / 11.6 (360) Mabuchi drawings face holes 2 × M2.6 × 0.45 on 16.0 Mabuchi drawings usable screw length 3.0 (365) / 4.0 (360) Mabuchi drawings Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - Mabuchi Motor (compiled catalogue, hosted by mikrocontroller.net): Carbon-brush and metal-brush motor datasheets incl. RS-360RH, RS-365SH, RS-385SH, RS-550PC, RS-555VC, RS-775VC dimension drawings — PDF — manufacturer datasheets [verify license at link] — https://mikrocontroller.net/attachment/641472/Mabuchi_Motors_Complete.pdf Free files (CC BY 4.0, Xem Studio; STEP + STL, 2 parts): https://xemstudio.com/files/hardware/dc-motor-365-size/index.json API: https://xemstudio.com/api/geometry?object=dc-motor-365-size