3D printable L-rod right-angle drive: gearless 90° elbow mechanism with sliding bent rods (STL, STEP) — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/l-rod-right-angle-drive/ (sheet CC BY 4.0; files Xem Studio Design License, https://xemstudio.com/license/) Basis: Elbow mechanism (gearless transmission): three L-pins slide in hubs on two shafts at 90° and transmit rotation 1:1. Catalog version: 2026-10-20 Overall (mm): length 87.1, width 87.1, height 42 - Resize: multiply every length by one factor k and the motion stays identical: angles, ratios, timing and the formulas below do not change, because a mechanism's motion depends only on the ratios of its lengths. Here, scales with k: elbow-hub, elbow-knob; stays the same: elbow-rod, elbow-frame. - Resize: fit clearances stay in mm (a slide fit is the same gap at any size); keep every printed wall and pin at least two nozzle widths; mass grows with k³ but part strength only with k², so at k = 2 parts are about 8× heavier and 4× stronger: check pins and thin links when scaling up. - Each rod slides in and out of its hub hole once per turn; both hubs turn at the same speed in opposite senses. - Holes are 0.25 mm per side over the octagonal rods; rods print flat on a flat face. - Knobs press onto the axles outside the frame; bore is nominal, add your press-fit allowance. - Checked at 0, 30, 60 and 90°: no part collides. file what overall mm elbow-hub Hub: Ø30 × 14 with three Ø4.8 rod holes on R10 and a Ø6 axle 30 × 30 × 49 elbow-rod L-rod (print 3): 4 mm octagonal legs, 39.5 mm each, 90° corner 41.665 × 41.665 × 4.33 elbow-knob Octagonal knob, Ø6 bore for the axle 19.753 × 19.753 × 8 elbow-frame L frame: two 4 mm walls at 90° with Ø6.4 axle holes 78.5 × 78.5 × 42 elbow-assembled Every part in place (frame, 2 hubs, 3 rods, 2 knobs), each its own solid 87.1 × 87.1 × 42 Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - IJERT: Design, Analysis and Fabrication of Gearless Power Transmission by using Elbow Mechanism — web — Publisher's page; dimensions are facts — https://www.ijert.org/design-analysis-and-fabrication-of-gearless-power-transmission-by-using-elbow-mechanism - IRJET (issuu): Design and Fabrication of Gearless Transmission using Elbow Mechanism — web — Publisher's page; dimensions are facts — https://issuu.com/irjet/docs/irjet-v8i5504 Free files (Xem Studio Design License, Xem Studio; STEP + STL, 5 parts): https://xemstudio.com/files/mechanisms/l-rod-right-angle-drive/index.json API: https://xemstudio.com/api/geometry?object=l-rod-right-angle-drive