3D printable lever ratchet with two arc pawls and spiral return spring (STL, STEP) — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/lever-ratchet-with-arc-pawls/ (sheet CC BY 4.0; files Xem Studio Design License, https://xemstudio.com/license/) Basis: Lever ratchet with two arc pawls: designed for 3D printing, exact nominal mm. Catalog version: 2026-10-20 Overall (mm): length 132.0, width 95.0, height 14.9 - Resize: multiply every length by one factor k and the motion stays identical: angles, ratios, timing and the formulas below do not change, because a mechanism's motion depends only on the ratios of its lengths. Here, stays the same: lever-ratchet-assembled; step to the nearest standard size (and redraw the hole or pocket it fits): lever-ratchet-spring. - Resize: fit clearances stay in mm (a slide fit is the same gap at any size); keep every printed wall and pin at least two nozzle widths; mass grows with k³ but part strength only with k², so at k = 2 parts are about 8× heavier and 4× stronger: check pins and thin links when scaling up. - Wheel OD 50, 24 teeth (15 degree steps), 10.2 thick so it spans both pawl layers. - Arc pawls: 1.4 mm strips sweeping 60 degrees at 0.5 mm outside the teeth, tooth just behind the radial face. - Return spring: spiral spring OD 30 with a 15 mm lever on a 5 mm square post, pushing the lever arm. - Kit: the base plate carries 5 mm pins (parts have 5.4 mm bores, 0.2 mm per side); every part prints flat on its own, and the assembled file shows them in place with 0.2 mm gaps, each part its own solid. file what overall mm lever-ratchet-assembled assembled: 4 parts in place 132 × 95 × 14.9 lever-ratchet-base lever ratchet base 132 × 95 × 14.9 lever-ratchet-wheel lever ratchet wheel 50 × 50 × 10.2 lever-ratchet-lever lever ratchet lever 114 × 68 × 5 lever-ratchet-spring lever ratchet spring 47.5 × 30 × 5 Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - Wikipedia: Ratchet (device) — web — Publisher's page; dimensions are facts — https://en.wikipedia.org/wiki/Ratchet_(device) - Wikipedia: Pawl — web — Publisher's page; dimensions are facts — https://en.wikipedia.org/wiki/Pawl Free files (Xem Studio Design License, Xem Studio; STEP + STL, 5 parts): https://xemstudio.com/files/mechanisms/lever-ratchet-with-arc-pawls/index.json API: https://xemstudio.com/api/geometry?object=lever-ratchet-with-arc-pawls