3D printable rack-and-pinion padlock: spiral-spring gear, rack bolt and zig-zag latch mechanism (STL, STEP) — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/rack-and-pinion-spring-padlock/ (sheet CC BY 4.0; files Xem Studio Design License, https://xemstudio.com/license/) Basis: Rack-and-pinion spring padlock: designed for 3D printing, exact nominal mm. Catalog version: 2026-10-20 Overall (mm): length 100.0, width 85.0, height 9.7 - Resize: multiply every length by one factor k and the motion stays identical: angles, ratios, timing and the formulas below do not change, because a mechanism's motion depends only on the ratios of its lengths. Here, stays the same: rack-padlock-assembled; step to the nearest standard size (and redraw the hole or pocket it fits): rack-padlock-bolt, rack-padlock-spiral-spring-gear. - Resize: Gears scale by the module m (pitch Ø = m·z, centre distance = m·(z₁ + z₂)/2): keep the tooth counts so the ratio stays, and choose a standard module (0.5, 0.8, 1, 1.25, 1.5, 2, 2.5, 3). - Resize: fit clearances stay in mm (a slide fit is the same gap at any size); keep every printed wall and pin at least two nozzle widths; mass grows with k³ but part strength only with k², so at k = 2 parts are about 8× heavier and 4× stronger: check pins and thin links when scaling up. - Gear: module 2, 16 teeth; rim on two spiral arms (0.9 mm) to a hub that keys on a 5 mm square post (4.6 mm post). - Bolt: 12-tooth module-2 rack with 7 sawtooth latch notches (7 mm pitch, 3.5 deep) and a finger tab. - Gear sits 0.3 mm farther out than nominal for backlash. - Latch: pawl with printed leaf spring; preload it against its post. - Kit: the base plate carries 5 mm pins (parts have 5.4 mm bores, 0.2 mm per side); every part prints flat on its own, and the assembled file shows them in place with 0.2 mm gaps, each part its own solid. file what overall mm rack-padlock-assembled assembled: 4 parts in place 100 × 85 × 9.7 rack-padlock-base rack padlock base 100 × 85 × 9.7 rack-padlock-bolt rack padlock bolt 87.398 × 18 × 5 rack-padlock-spiral-spring-gear rack padlock spring gear 35.975 × 35.975 × 5 rack-padlock-zigzag-latch rack padlock latch 35.2 × 17.7 × 5 Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - Wikipedia: Rack and pinion — web — Publisher's page; dimensions are facts — https://en.wikipedia.org/wiki/Rack_and_pinion - Wikipedia: Padlock — web — Publisher's page; dimensions are facts — https://en.wikipedia.org/wiki/Padlock Free files (Xem Studio Design License, Xem Studio; STEP + STL, 5 parts): https://xemstudio.com/files/mechanisms/rack-and-pinion-spring-padlock/index.json API: https://xemstudio.com/api/geometry?object=rack-and-pinion-spring-padlock