3D printable ratchet wheel and pawl: one-way sawtooth wheel, plain and spring pawl (STL, STEP) — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/ratchet-wheel-and-pawl/ (sheet CC BY 4.0; files Xem Studio Design License, https://xemstudio.com/license/) Basis: Ratchet and pawl: the pawl rides over the sloped flanks one way and catches the steep face the other way; the contact normal must pass on the engagement side of the pawl pivot (FIRGELLI). Catalog version: 2026-10-20 Overall (mm): length 60, width 60, height 5 - Resize: multiply every length by one factor k and the motion stays identical: angles, ratios, timing and the formulas below do not change, because a mechanism's motion depends only on the ratios of its lengths. Here, scales with k: ratchet-pawl-flex; stays the same: ratchet-wheel-od40-12t, ratchet-wheel-od60-24t, ratchet-pawl. - Resize: fit clearances stay in mm (a slide fit is the same gap at any size); keep every printed wall and pin at least two nozzle widths; mass grows with k³ but part strength only with k², so at k = 2 parts are about 8× heavier and 4× stronger: check pins and thin links when scaling up. - Wheel turns clockwise past the pawl, locks counter-clockwise. - Place the pawl pivot so the pawl points along the tooth's steep face; then load pulls the pawl in. - The flex pawl's leaf spring rests against a post or wall to keep the tip on the teeth. - Print flat; PETG or nylon for the pawl. file what overall mm ratchet-wheel-od40-12t Ø40 ratchet wheel, 12 teeth 4 mm deep, Ø5 bore 40 × 40 × 5 ratchet-wheel-od60-24t Ø60 ratchet wheel, 24 teeth, 4 spokes, 6 mm square key 60 × 60 × 5 ratchet-pawl Pawl: 24.5 mm long, Ø3 pivot hole, pointed tip 24.5 × 9 × 5 ratchet-pawl-flex Pawl with a printed leaf spring (1.2 mm): no separate spring needed 32 × 16.5 × 5 Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - FIRGELLI: Pawl Mechanism Explained: Self-Locking Geometry — web — Publisher's page; dimensions are facts — https://www.firgelliauto.com/en-fr/blogs/mechanisms/pawl - FIRGELLI: Ratchet-wheel Stops: Tooth Geometry and Holding Torque — web — Publisher's page; dimensions are facts — https://www.firgelliauto.com/blogs/mechanisms/ratchet-wheel-stops Free files (Xem Studio Design License, Xem Studio; STEP + STL, 4 parts): https://xemstudio.com/files/mechanisms/ratchet-wheel-and-pawl/index.json API: https://xemstudio.com/api/geometry?object=ratchet-wheel-and-pawl