3D printable rubber-band bowtie detent slider: three-position snap slider (STL, STEP) — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/rubber-band-bowtie-detent-slider/ (sheet CC BY 4.0; files Xem Studio Design License, https://xemstudio.com/license/) Basis: Rubber-band bowtie detent slider: designed for 3D printing, exact nominal mm. Catalog version: 2026-10-20 Overall (mm): length 100.0, width 40.0, height 12.2 - Resize: multiply every length by one factor k and the motion stays identical: angles, ratios, timing and the formulas below do not change, because a mechanism's motion depends only on the ratios of its lengths. Here, stays the same: bowtie-slider-assembled. - Resize: fit clearances stay in mm (a slide fit is the same gap at any size); keep every printed wall and pin at least two nozzle widths; mass grows with k³ but part strength only with k², so at k = 2 parts are about 8× heavier and 4× stronger: check pins and thin links when scaling up. - Notches: 90 degree V, 2.5 deep, 20 mm apart; detent nose offset 0.4 mm. - Slider 80 × 10 × 5 runs between rails with 0.4 mm gaps; the bowtie runs in a 12.8 mm guide. - Any small rubber band works; loop it from post to post behind the bowtie's back. - Kit: the base plate carries 5 mm pins (parts have 5.4 mm bores, 0.2 mm per side); every part prints flat on its own, and the assembled file shows them in place with 0.2 mm gaps, each part its own solid. file what overall mm bowtie-slider-assembled assembled: 3 parts in place 100 × 40 × 12.2 bowtie-slider-base bowtie slider base 100 × 40 × 11.2 bowtie-slider-bar bowtie slider bar 80 × 10 × 9 bowtie-detent bowtie slider detent 12 × 13.934 × 5 Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - Wikipedia: Detent — web — Publisher's page; dimensions are facts — https://en.wikipedia.org/wiki/Detent - Wikipedia: Rubber band — web — Publisher's page; dimensions are facts — https://en.wikipedia.org/wiki/Rubber_band Free files (Xem Studio Design License, Xem Studio; STEP + STL, 4 parts): https://xemstudio.com/files/mechanisms/rubber-band-bowtie-detent-slider/index.json API: https://xemstudio.com/api/geometry?object=rubber-band-bowtie-detent-slider