3D printable spiral-spring clicker: push-button snap clicker with a printed clock spring (STL, STEP) — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/spiral-spring-clicker/ (sheet CC BY 4.0; files Xem Studio Design License, https://xemstudio.com/license/) Basis: Spiral-spring clicker: designed for 3D printing, exact nominal mm. Catalog version: 2026-10-20 Overall (mm): length 84.0, width 68.0, height 9.7 - Resize: multiply every length by one factor k and the motion stays identical: angles, ratios, timing and the formulas below do not change, because a mechanism's motion depends only on the ratios of its lengths. Here, step to the nearest standard size (and redraw the hole or pocket it fits): spring-clicker-assembled, spring-clicker-base, spring-clicker-spring, spring-clicker-button. - Resize: fit clearances stay in mm (a slide fit is the same gap at any size); keep every printed wall and pin at least two nozzle widths; mass grows with k³ but part strength only with k², so at k = 2 parts are about 8× heavier and 4× stronger: check pins and thin links when scaling up. - Spring: spiral_spring OD 40, 1.0 mm arms, 1.5 turns, 30 mm lever; hub keys on a 4.6 mm square post. - Button runs between rails and lifts the lever at 35 mm from the centre. - Lever tip rests 0.3 mm off the 5 mm stop post. - Kit: the base plate carries 5 mm pins (parts have 5.4 mm bores, 0.2 mm per side); every part prints flat on its own, and the assembled file shows them in place with 0.2 mm gaps, each part its own solid. file what overall mm spring-clicker-assembled assembled: 3 parts in place 84 × 68 × 9.7 spring-clicker-base spring clicker base 84 × 68 × 9.7 spring-clicker-spring spring clicker spring 72.5 × 40 × 5 spring-clicker-button spring clicker button 12 × 37 × 5 Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - Wikipedia: Spring (device) — web — Publisher's page; dimensions are facts — https://en.wikipedia.org/wiki/Spring_(device) - Wikipedia: Clicker — web — Publisher's page; dimensions are facts — https://en.wikipedia.org/wiki/Clicker Free files (Xem Studio Design License, Xem Studio; STEP + STL, 4 parts): https://xemstudio.com/files/mechanisms/spiral-spring-clicker/index.json API: https://xemstudio.com/api/geometry?object=spiral-spring-clicker