JST PH, XH, EH and GH connectors, 2–8 pin

sizes

41 in table

Notes

• XH (2.5 mm pitch, the white 'balance lead' connector): header 2 pin is about 7.4 × 5.75 × 7 mm; each extra pin adds 2.5 mm. PH (2.0 mm): 2-pin header about 5.9 × 4.5 × 6 mm, +2.0 mm per pin.
• EH is 2.5 mm pitch like XH but lower (5.4 mm) and narrower; GH is the 1.25 mm pitch latching micro connector on drones and Pi cameras.
• Leave 8 mm above a vertical XH header for the mating plug and finger room; 10 mm for the wire exit on horizontal headers.
• Bounding boxes in the table are computed from the STEP files; they include the pins below the board.

Sizes

Where the files are

Files below are rehosted from this library under its share-alike license, with its license and credits beside them. "verify" = check the license at the link before commercial use.

KiCad

kicad-packages3D library (origin of these files)

STEP, WRL

CC BY-SA 4.0 with KiCad exception

Free files

★ Free files 41 parts. From the KiCad library contributors, rehosted with their license and credits. CC BY-SA 4.0 (KiCad library license, with the KiCad exception). index.json

Plain text: sheet.txt · JSON: /api/geometry?object=jst-connectors

Fits with